Menu
ENGLISH
中文
Email: sales2@corrtest.com.cn
Phone:+86 13469965984

FAQs

How should I install the CS Studio sofware(single-channel potentiostat)?

Source：Corrtest Time：2021-12-02 View：0

 

Single channel models – USB Cable (CS350M/CS310M/CS300M/CS150M/CS120M)

1. Using the USB cable to connect the potentiostat with a computer.
2. Power on the instrument, open the “software installation” folder in the CD and USB flash disk., right click the “CS studio6 setup”, and run as administrator.

 
3. Firstly, install the drivers. After finishing it, go to the computer management → device manager→ Ports (COM & LPT). There, it will appear “STM… Virtual COM Port (COM x)”.  As is shown below.

4. Secondly, install the runtime environment. If your computer has already installed it, there will be a prompt saying you have already installed.
If it hasn’t been installed in your computer, just follow the steps to finish installation of runtime.
5. Click install CS Studio6. Created a shortcut is on the desktop.
6. Run the software as administrator. Then the model and serial number will be shown. It means the instrument has been successfully connected.
Back to the list

About Us   Potentiostat/Galvanostat   Accessories   Support   Contact Us  

Copyright By © 2008-2024 Wuhan Corrtest Instrument Corp., Ltd

This website stores cookies on your computer. These cookies are used to improve your website experience and provide more personalized services to you, both on this website and through other media. To find out more about the cookies we use, see our Privacy Policy.
We won't track your information when you visit our site. But in order to comply with your preferences, we'll have to use just one tiny cookie so that you're not asked to make this choice again.
Decline
Accept